How to Program Genesis Garage Door Opener
Trying to program your HomeLink Genesis garage door opener? We’re here to help! The HomeLink Wireless Control System provides a convenient way to replace up to three handheld radio-frequency (RF) transmitters used to activate compatible devices such as gate operators, garage door openers, entry door locks, security systems, and home lighting. For more Genesis garage door opener troubleshooting from our Genesis service department, stop in to Genesis of Algonquin today!
Programming a New HomeLink Button
Before you start, it is advised to park the vehicle outside of the garage when programming a garage door opener. It is also recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio-frequency signal. Finally, be sure to place the ignition switch to the ON position for programming your HomeLink garage door opener.
How to Program the Genesis Garage Door Opener
To program your Genesis home access garage door opener, simply follow the instructions below.
- Press and release the HomeLink button (1), (2) or (3), you would like to program. The HomeLink indicator light will flash orange slowly.
- Position the garage door opener remote 1 – 3 inches (2-8 cm) away from the HomeLink buttons.
- While the HomeLink indicator light is flashing orange, press and hold the hand-held remote button. Continue pressing the hand-held remote button until the HomeLink indicator light changes from orange to green. You may now release the hand-held remote button.
- Wait until your garage door comes to a complete stop, regardless of position, before proceeding to the next steps.
- Press and release the HomeLink button you are programming and observe the indicator light. If the indicator light remains constant green, your device should operate when the HomeLink button is pressed. At this point, if your device operates, programming is complete. If the indicator light rapidly flashes green, firmly press, hold for two seconds and release the HomeLink button up to three times in a row slowly to complete the programming process. Do not press the HomeLink button rapidly. At this point if your device operates, programming is complete. If the device does not operate, continue with step 6.
- At the garage door opener motor, locate the “Learn,” “Set” or “Program” button, This can usually be found where the hanging antenna wire is attached to the motor-head unit (see the device’s manual to identify this button). The name and color of the button may vary by manufacturer. Note: A ladder and/or second person may simplify the following steps.
- Firmly press and release the “Learn,” “Set” or “Program” button. You now have 30 seconds in which to complete the next step.
- Return to the vehicle and firmly press, hold for two seconds and release, the HomeLink button up to three times in a row slowly. Do not press the HomeLink button rapidly. At this point programming is complete and your device should operate when the HomeLink button is pressed and released.
Visit Genesis of Algonquin!
Looking for a Genesis dealer near me? At Algonquin Genesis, you’ll experience an amazing assortment of premium 2023 Genesis models that can cater every driving need and desire. Once you have your sights on a specific Genesis in our inventory, one of our experienced and financing savvy staff will help you find the perfect loan or lease option that will allow you to finally drive home a brand-new Genesis. We will still strive to provide you with a kind of experience that is world class, long after you have driven home your Genesis. Visit us to learn more about Genesis garage door opener programming today!